AEG CF300 Operating Instructions Manual page 20

10. What to do if ...
• no coffee runs out of the spouts:
– Check that the water tank is cor-
rectly seated!
– Fill the water tank!
– Check the correct seating of the drip
catcher!
• coffee only drips out of the spouts:
– Set the grinding texture to a coarser
setting.
• there is too little froth produced when
frothing the milk:
– Always use cool, fresh (low fat) milk!
– Use a suitable container (e.g. jug)!
– Also cool the container if necessary!
– Dismantle the swivelling nozzle and
clean (CF 300)!
– Clean the frothed milk spout
(CF 400)!
• the temperature of the coffee is too
low:
– Pre-warm cups with steam or hot
water!
– Set a higher coffee temperature (see
Section 3.3).
Caution: Sugar and milk lower the
temperature of the coffee!
– Descale the appliance.
• the brewing process is interrupted
after grinding and "FILL BEANS"
appears in the display:
– Fill the bean container as the brew-
ing unit has detected that too few
beans have been ground; as a result
the brewing cycle has been inter-
rupted.
• the spent coffee container is stuck in
the appliance:
– Pull out the drip catcher together
with the spent coffee drawer and
carefully remove the spent coffee
container from the appliance. Refit
the drip catcher with the spent cof-
fee drawer, but without the spent
coffee container and wait until the
process is complete and the last type
of coffee selected appears in the dis-
play. Then insert the drip catcher
with the spent coffee container and
spent coffee drawer!
• "SERVICE 1" appears in the display:
– The appliance, or else the ambient
temperature is too cold.
Unplug the appliance. Wait approx.
2 hours before switching on the
appliance again!
If this malfunction continues to be
displayed, please contact customer
service.
• "SERVICE 5" or "SERVICE 8" appears in
the display:
– Switch off the appliance, unplug
from the mains, plug into the mains
again, and switch on the appliance
again. If this malfunction is no
longer indicated, the appliance is
again ready for use.
If this malfunction continues to be
displayed, please contact customer
service!
• the grinder is making loud noises:
– Check the grinder for foreignbodies.
If necessary, have the appliance
checked by an AEG Service Force
Centre.
• the appliance is to be transported:
– Keep the original packaging to pro-
vide protection during transport.
– Protect the appliance from knocks.
– If there is a risk of frost, drain the
heater system by drawing off steam
prior to transport:
– Place a container under the nozzle.
– Switch off the appliance and turn
the steam selector (Figure 1/G)
clockwise to the "Steam" posi-
tion.
– Press the button on the coffee
selector (Figure 1/S) for a few sec-
onds. "SYSTEM EMPTYING" appears
in the display.
Steam exits from the steam tube
and the appliance switches off
automatically.
– Empty the bean container, water
tank and collecting tray.
g
33