Filling The Bean Container; Adjusting The Grinding Texture; Switching On The Appliance; Setting The Language - AEG CF300 Operating Instructions Manual

g
0 Refit the water tank in the appliance
and press it down until it engages so
the valve on the base is opened.
For aromatic coffee, you should:
• change the water in the tank daily,
• not use mineral or distilled water and
• clean the water tank at least once a
week in normal washing up water (not
in a dishwasher). Then rinse with clean
water.

2.2. Filling the Bean Container

(Figure 6)
You can use both espresso and filter
coffee beans!
0 Open the lid of the bean container
(Figure 1/F) and fill the container with
roasted coffee beans (do not use fro-
zen or caramelised beans). Ensure that
no foreign bodies enter the bean con-
tainer.
0 Close the lid.
3
When using for the first time:
The first brewing procedure will be
interrupted by the display "FILL
BEANS". The appliance is not ready
until after the second cup of coffee, as
the coffee channel must first be filled
with ground coffee. For this reason you
should trigger two brewing procedures
(see Section 3, Making Coffee).
2.3. Adjusting the Grinding
Texture (Figure 7)
To release the full aroma from the
beans, you can adjust the grinding tex-
ture to suit the roasting of the beans.
The grinding texture adjustment is on
the rear right of the appliance.
Important: The grinding texture is only
to be adjusted when the grinder is in
operation.
Starting from the factory medium
setting, turn the adjustment knob
clockwise for darker beans (coarser
grinding texture), anticlockwise for
lighter beans (finer grinding tex-
ture).
24

2.4. Switching On the Appliance

(Figure 8)
0 Switch the appliance on using the
On/Off button (Figure 1/A).
When using for the first time:
"HOT WATER CYCLE NECESSARY"
appears in the display to indicate that
the system needs to be filled.
0 Place an empty cup under the nozzle
(Figure 1 H/J).
0 Turn the steam selector (Figure 1/G)
anticlockwise until it reaches the
"Hot water" position. "SYSTEM
FILLING" appears in the display. After
a few seconds this procedure stops
and "SET STEAM/WATER DIAL TO ZERO"
appears in the display. Then "HEATING
UP" flashes in the display.
0 Place an empty cup under the coffee
outlet (Figure 1/N). When the appli-
ance has reached the coffee tempera-
ture, the "RINSE MACHINE, PRESS
BUTTON" display appears.
0 Press the coffee selector button to
start brewing.
Brewing stops automatically. The type
of coffee that was selected last appears
in the display, e.g., "1 CUP REGULAR,
PRESS BUTTON". The appliance is
ready to prepare another coffee (see
Section 3).

2.5. Setting the Language

0 Turn the programme selector (Fig. 1/Q)
to Position 8. "SPRACHE DEUTSCH"
(language german) appears in the dis-
play.
0 Press the selection button on the pro-
gramme selector (Figure 1/Q) until the
required language appears in the dis-
play.
0 Return the programme selector to
Position 1 to store the required lan-
guage.