Electrolux EBA63810X Instructions Manual page 10

x 16
Position the rails on the sides of the cabinet as
shown in the figure. Fix with the screws, then
extract them completely. If the coffee maker is
installed over a warmer drawer, use the top sur-
face of this as a reference to position the rails.
In this case, there will be no surface to rest the
rails on.
x 1
Fix the power cable with the clip.
The power cable must be long enough to allow
the appliance to be extracted from the cabinet
to fill the coffee bean container.
The appliance must be earthed in compliance
with legislation.
Electrical connections must be performed by a
qualified electrician
instructions.
x 2
following the
11
x 4
Position the appliance on the rails, making sure
the pins are correctly inserted in the housings,
then fix it with the screws supplied.
If the height of the appliance requires adjusting,
use the spacer disks provided.
x 1
If necessary, fit the trim at the bottom of the
frame to compensate for differences in alignment
with other appliances.
x 4
If necessary, correct alignment of the appliance
by positioning the spacers supplied under or at
the sides of the support.
GB
x 8