Printhead Assembly Electronic Adjustment - Lexmark E360d Service Manual

4513-420, -430

Printhead assembly electronic adjustment

A step-by-step process to align a new printhead.
Note: Before aligning the printhead electronically, first align the printhead mechanically, if needed. See
"Printhead assembly mechanical adjustment" on page 3-17
1.
Enter the Diagnostics menu. See
2.
Press
3.
Press
4.
In the Registration menu, select the right margin setting.
5.
To determine the margin setting, choose the value that is closest to the darkest bar on the center graph of
the margin page. Add that value to the current right margin setting printed on the left hand side of the
margin page. (The right margin setting will also appear on the operator panel display.) For example, if the
right margin setting on the page is -2, and the number that is closest to the darkest line on the graph is 3
(-2+3), then the right margin setting will be equal to +1.
6.
Press or
7.
Print the Quick Test page again and check that the darkest line in the center graph is equal to zero. If it is,
then check to see if the left, top, and bottom margins are detected. If it is not, then repeat step 5.
Note: The alignment of the left margin positions the black plane to the right or left. The alignment of the right
margin does not alter the margins and should only be used to adjust the printhead.
3-16
Lexmark™ E360d, E360dn
"Entering Diagnostics menu" on page
to enter the Registration menu.
to print the Quick test page.
Quick Test page
(sample only; use actual sheet)
to the desired setting, and press
3-5.
.