Problems and actions needed
Never attempt any repairs or work on the cooker which could cause injury or damage the product. If you cannot
solve the problem after checking the list below, contact a service company approved by the supplier.
Problem
The cooker has no electrical supply
The rear left hotplate is not working
(230-volt cooker only)
Boiling/frying takes a long time
The oven light is not working
The door safety catch isn't working
The roasting sensor is not working
The clock is not showing the right time/not working
The timer is not working
At the end of the cooker's life
Action needed
Check that:
•
THE FUSE
•
THE PLUG
•
THE RCD
The cooker has an electrical inter-lock so that the rear left
hotplate cannot heat while the oven Swift Start function is on.
This hotplate can be used as soon as the oven Swift Start heat-
ing is finished.
Check you have a suitable pan that conducts heat properly
(see page 10)
Replace broken bulb (see page 21)
Activate the door safety catch (see page 6)
Check that the sensor is correctly plugged in inside the oven.
Take it out and plug it in again. Set the required temperature
(see page 17)
Set the correct time (see page 6)
Set the time required (see page 13)
Disconnect the cooker from the electrical supply.
1
Cut off the electrical lead, as close as possible to
2
the rear of the cooker.
Make sure that the oven door safety catch has been
3
deactivated, to remove the risk of children locking
themselves inside the oven.
Contact your local council to find out where you can
dispose of your cooker.
Problems and actions needed
(
) has not gone
S
is pushed in correctly
(if fitted) has not tripped
27