Step 6, Level Refrigerator; Step 7, Level Doors; Step 8 Screw Down Support Leg - GE ZFSB23DSS Installation Instructions Manual

STEP 6 LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the rollers
located near the bottom hinges.
Rollers
Rollers have three purposes:
• The rollers adjust so that the door closes easily when
716Dia7
opened about halfway. (Raise the front about 5/8"
[16 mm] from the floor.)
• Rollers adjust to allow the refrigerator to be firmly
positioned on the floor and to prevent rocking
when the doors are opened and closed.
• The rollers allow you to move the refrigerator from the
wall for cleaning.
To Adjust the Rollers:
Roller Adjusting Screw
• Use a 3/8" hex socket or wrench to turn the
adjustment screws. Turn the screws clockwise to raise
the refrigerator, turn counterclockwise to lower it.
716Dia8
Roller Adjusting Screws
• Use a 5/16" hex socket to turn the screws for the
rear rollers. Turn the screws clockwise to raise the
refrigerator, counterclockwise to lower it.
716Dia3
Installation Instructions
Raise
9
STEP 7 LEVEL THE DOORS
If the doors are not evenly aligned at the top, the
refrigerator door can be adjusted.
• Use a 7/16" hex socket or wrench to turn the door
adjusting screw. Turn the screw to the right to raise
the door, turn left to lower the door.
NOTE: A nylon plug is imbedded in the threads of
the pin. The plug is designed to prevent the pin from
turning. A wrench must be used to turn the pin.
716Dia4
• Turn the wrench one or two times. Open and close the
refrigerator door to check alignment with the freezer
door at the top. Adjust again if necessary.

STEP 8 SCREW DOWN SUPPORT LEG

Screw down the support leg until it touches the floor.
This will prevent door misalignment.
Doors Should
Align at Top
Raise