GE Monogram ZBD5600 Use And Care Manual page 18

The interior light bulb is located in the rear top right
Light Bulb
corner.
Replacement
To replace—
(on some
1. Make sure the dishwasher is disconnected from the
models)
2. Unscrew the plastic lens counterclockwise.
3. Remove the bulb and replace with a maximum 15 watt
4. Make sure the seal is correctly fitted to the plastic lens
For best performance, check the water fill level of your
Water fill
dishwasher.
level
Once the dishwasher is fully connected, run it through a
complete RINSE & HOLD cycle to ensure it is emptying
and filling correctly. For low water pressure situations run
the RINSE & HOLD cycle 3 times. Half way through the
final RINSE & HOLD cycle, pause the dishwasher and
check the water level inside the dishwasher. If the water
level is not above the minimum water level (marked on the
lower spray support tower), increase the fill level.
For Model ZBD5600—Remove the front kickplate and
change the Fill Time switch setting.
For Model ZBD5700 and ZBD5900—
1. Ensure the dishwasher is not running through a cycle.
2. Press the CLEAR button to select fill time, as per chart
3. To test time, press DELAY START. The dishwasher
4. Once complete, press the WATER TEMP button to
18
power supply.
bayonet bulb no larger than 1 in diameter and 2
long. Order part # WD21X10055.
and screw it firmly into place.
CAUTION: The plastic lens must be secured before
reconnecting power to the dishwasher.
ATTENTION : Il faut remettre la lentille de plastique
en place avant de rétablir le courant au lave-vaisselle.
Depress the WATER TEMP button for ten seconds
until the second buzzer sounds.
(80 seconds is the factory setting).
will start filling. Listen for the dishwasher to complete
filling. Once filled, the fill level must be checked to
ensure fill time is correct.
exit fill time mode.
Care and Cleaning
Light bulb
Maximum level
Fill time switch
Dishwasher
Unscrew lens in a
counterclockwise
direction
Plastic lens
Minimum level
Continue to press the
CLEAR button until the desired
indicator is illuminated.
Cycle Status
Indicators Fill time
PRE-WASH 75 seconds
WASH 80 seconds
RINSE 90 seconds
DRY 100 seconds
CLEAN 110 seconds