GE Monogram ZBD5600 Use And Care Manual page 16

Removing
and Cleaning
the Spray
Arms and
Glass Trap
16
Periodically, remove and clean the spray arms
to make sure that none of the nozzles have
become blocked.
To remove the lower spray arm, grasp the
center of the spray arm and pull upwards, it will
unclip. When replacing, make sure the spray
arm is fully seated.
The plastic cone on the underside of the spray
arm can be detached by unscrewing it
counterclockwise.
To remove the upper spray arm, carefully
unscrew the spray arm from the plastic tower.
To achieve this, hold the inner tower steady
and unscrew the spray arm clockwise. To
replace the spray arm, carefully screw the spray
arm counterclockwise onto the inner tower.
To clean the upper and lower spray arms, rinse
them under running water and make sure spray
nozzles are clear.
The glass trap is located in the stainless steel
filter at the base of your dishwasher. The glass
trap is used to collect larger food items and
other foreign objects, which may be too big to
pass through the drain pump. For best wash
performance, check the glass trap occasionally.
To remove the glass trap, twist the two vertical
handles counterclockwise, rotate the glass trap
and lift. To clean the glass trap, empty and rinse
thoroughly. To replace, reverse these steps
making sure the glass trap locks into place.
Care and Cleaning
Dishwasher
Pull up to remove
Rotate counterclockwise to
remove cone
Rotate counterclockwise
and lift to remove glass trap