Yamaha DVX-1000 Owner's Manual page 40

DVD setup menu options
CONTRAST
Increase the value to sharpen the picture contrast or
vice versa. You can adjust the value from -16 to +16.
Zero (0) is the average contrast.
TINT
Increase or decrease the value to change the color
phase of the picture. You can adjust the value from -9
to +9. Zero (0) is the average setting value.
COLOR
Increase the value to enhance the color in your picture
or vice versa. You can adjust the value from -9 to +9.
Zero (0) is the average color setting value.
5 Press
/ to adjust the setting that best suits your
personal preference.
6 Repeat steps 4 and 5 to adjust other color features if
desired.
7 Press ENTER to confirm.
Note
All picture settings are not available for HDMI output.
38
En
Adjusting the advanced picture
settings
You can fine-tune the following video parameters.
We recommend setting the aspect ratio on your TV if the
function is available.
[DCDI]
DCDi (Directional Correction Deinterlacing) computes
and tracks the angle of the screen edge to fill in the
missing pixel on the TV screen. DCDi optimizes the
image quality significantly, especially during the slow
motion playback. This function is available for
progressive scan output only.
1 Select [ADV PICTURE] in [VIDEO SETUP PAGE].
2 Press
/ to highlight [DCDI], then press
OFF
Select this to disable the DCDi function.
ON
Select this to enable the DCDi function.
3 Press
/ to select a setting and press ENTER
to confirm.
[GAMMA]
Adjust the intensity of the picture non-linearly. A positive
value enables you to bring out low level detail in dark
scenes, while a negative value emphasizes contrast. This
function is not available for HDMI output.
You can adjust the value from -7 to +7.
1 Select [ADV PICTURE] in [VIDEO SETUP PAGE].
2 Press
/
to highlight [GAMMA], then press
.
3 Press
/ to select a setting and press ENTER to
confirm.
.