Using A Usb Device - Yamaha DVX-1000 Owner's Manual

Multi-angle playback
During playback, use /
picture on the TV screen.
: flips the picture vertically.
: flips the picture horizontally.
: rotates the picture anti-clockwise.
: rotates the picture clockwise.
Scan effect
Press ANGLE repeatedly to choose a different scan effect.
→
Various scan effects appear in the top left corner of
the TV screen.
/ / to rotate/flip the

■ Using a USB device

You can play back MP3, WMA and AAC files saved on
your supported USB device.
Supported USB devices
The DVD receiver supports USB mass storage class
devices (e.g., flash memories, card readers, portable audio
players) using FAT12, FAT16 or FAT32 format.
Notes
– Some devices may not work properly even if they
meet the requirements.
– If a message saying that the device is not supported
appears on the TV screen when you connect the
USB device, follow the procedure below.
– Set the DVD receiver to the standby mode, and
then turn it on again.
– Disconnect the device when the DVD receiver is
in the standby mode, then connect it again and
turn on the DVD receiver.
– Connect the AC adapter if the adapter is supplied
with the device.
If a message saying that the device is not supported
still appears even after you perform this procedure,
the device is not playable with the DVD receiver.
– If a message saying that the device is not supported
(because USB current protection is active) appears
on the TV screen, the device is not playable with
the DVD receiver because the power consumption
of the device is too high.
– The DVD receiver cannot read more than two card
reader slots at once, though it can recognize up to
six slots. The first slot has priority.
– For an external hard disk drive, the DVD receiver
is compatible with size of 80 GB or less.
– Do not connect devices other than USB mass
storage class devices: USB chargers, USB hubs,
PCs, etc.
Playing data files
Yamaha and suppliers accepts no liability for the loss of
data saved on the USB devices connected to the DVD
receiver. As a precaution, it is recommended that the files
are tested after they have been saved on.
1 Connect your USB device to the USB terminal of the
DVD receiver (see "USB terminal" on page 19).
2 Press USB.
The reading time may exceed 30 seconds due to the
number of files/folders.
→
The file menu appears on the TV screen.
3 Follow the procedure in "Playing MP3/WMA/JPEG/
DivX® discs" on page 29.
Disc operation
4
31
En