JVC KW-AVX838 Instructions Manual page 35

Sound
Menu item
Fader/Balance
Fader/Balance
Reset
Fader 0
Balance 0
Back Exit
Volume Adjust *
6
Subwoofer Level
High Pass Filter
Low Pass Filter
Amplifier Gain
Loudness
Rear Speaker *
7
*
6
For "DISC/USB": You can make the adjustments separately depending on the audio format—Dolby digital/MPEG
Audio and the others.
*
7
Only for KW-AVX838/KW-AVX830.
Selectable setting/item
Fader : Adjust the front and rear speaker output balance.
z
F6 to R6; Initial 0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
z
L6 to R6; Initial 0
5 ∞ 2 3
Press [ / / / ] or drag [
• To clear the adjustment, press [Reset].
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears if an FM broadcast is selected as the source.
z
–12 to +12; Initial 00
Adjust the subwoofer output level.
z
00 to 08; Initial 08
z
Through : Select when the subwoofer is not connected.
z
On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the subwoofer.
z
55Hz, 85Hz, 120Hz
You can change the maximum volume level of this unit.
z
Off : Deactivates the built-in amplifier.
z
Low : VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
z
High : VOL 00 to 50
• If you change the setting from <High> to <Low> while the volume level is set
higher than "VOL 30," the unit automatically changes the volume level to "VOL
30."
You can activate/deactivate the loudness function.
z
Off : Cancels.
z
On : Boost low and high frequencies to produce a well-balanced
sound at a low volume level.
You can activate/deactivate the rear speakers.
• This setting takes effect only when Dual Zone is activated. (
z
Off : Deactivate the rear speakers.
z
On : Activate the rear speakers.
35
] to adjust.
Initial: Underlined
28)