Sound Equalization; Using A Rear View Camera - JVC KW-AVX838 Instructions Manual

Sound equalization

~
Ÿ
Select a sound mode.
Equalizer
Flat
Natural
Dynamic
Vocal Boost
Bass Boost
Super Bass
Back Edit
Move to other six sound modes
• You can also change the sound mode by
pressing the short cut icon. (
Storing your own adjustments
You can store your adjustments into <User1>,
<User2>, and <User3>.
1
Repeat steps ~ and Ÿ, then...
Back Edit

Using a rear view camera

• To use a rear view camera, the REVERSE GEAR SIGNAL lead connection is required. For connecting a rear view
camera, see the Installation/Connection Manual.
Displaying the rear view screen
The rear view screen is displayed when you shift the
gear to the reverse (R) position.
• While the pictures through the camera are shown on
the screen, no message will be displayed.
Equalizer
60 100 1.0k 2.5k 10k 15k
Exit
7)
Exit
29
2
Select the band (1), frequency (2),
adjust the volume (3), then adjust the
quality factor to make the sound natural
(4).
Frequency
User Store
User1
User2
User3
Freq 60 Hz
60
Q 1.0
Back
Quality factor*
3
Select <User1>, <User2>, or <User3> to
store the adjustment.
The adjustment is stored.
• When <High Pass Filter> is set to <On>, the
setting of low band is invalid. Select <Through> to
activate the low band setting. (
* When adjusting "High" band, the quality factor value is
fixed.
• When you perform one of the following operations,
the rear view screen is cleared.
– Press DISP.
– Shifting the gear to another position other than the
reverse (R) position.
Band
Low Mid High
100 1.0k 2.5k 10k 15k
Exit
35)