Westerbeke 20B TWO Tehnical Manual page 39

Governor Levers' Disassembly and Reassembly
1. Removal of the shaft.
a. Remove the expansion plug, taking care not to
scratch the gear case.
b. Pull out the grooved pin.
2. Installation of the shaft.
a. Install the shaft in the reverse order of removal.
b. After installing the shaft, press-fit the expansion plug
into the shaft hole in the gear case.
Gear Case Installation
Tightening torque:
4-5kg.m
Sealant: HERMESEA
H1 or THREE-BOND 1344
Gear Case Assembly
Tightening torque
O.8-1.0kg.m
~
Taper plug tightening
torque: 1.5-2.2kg.m
37
Expansion plug
Gear case
Installing
Governor
Shaft
Grooved pin
Projection
approx.2mm
Section A-A
Westerbeke Engines