Westerbeke 20B TWO Tehnical Manual page 38

Front Oil Seal Replacement
1. Remove the front oil seal.
2. Press-fit the new front oil seal.
CAUTION
Apply a thin coat of engine oil to the circumference and lip of the oil seal.
Governor Shaft Bushings' Replacement
1. Remove the expansion plug and draw the bush-
ings out.
2. Press-fit the new bushings into positions shown in
the figure at right.
Governor System Inspection
Check the governor system parts. If any parts are
found defective, repair or replace them.
Westerbeke Engines
36
To be flush with
this plane
To be in contact
with bottom
Press· fitting Governor Shaft Bushing
Check springs
for fatigue.
Check shaft
for flaws.
Check sliding sleeve
joint for wear and damage.
Check weight for wear and damage.