June 2012
2. Follow the prompts on the installation window.
Should driver installation fail to start automatically, you will be prompted
to install it manually. Follow the procedure in
3. Click Finish when done.
3.3
Installing drivers manually
Notes
•
If you have previously installed a pre-release version of drivers, follow the procedure in
Appendix D
•
The following procedure only applies to Windows XP operating systems. On Windows 7
operating systems, drivers are automatically installed.
•
There are two drivers that have to be installed manually; one for ports and another for USB
controllers. You need to complete the driver installation on the Found New Hardware
Wizard twice to install both drivers.
1. Connect the USB Fieldbus Interface to the computer using the USB cable
provided.
This facilitates manual installation of drivers through the Found New
Hardware Wizard.
first before installing new drivers manually.
User's Manual
Section
3.3.
11
Need help?
Do you have a question about the USB Fieldbus Interface and is the answer not in the manual?