Esc> A Get Printer Status; Esc> @ Reset Printer; Esc> * Restore Default Settings; Esc> F 1 N Skip "N" Lines - Dymo LabelWriter 400 Series Technical Reference Manual

This command specifies the roll on which the printer output should be imaged. In
Automatic Selection mode, the printer assumes that both rolls have the same media, and
it will toggle back and forth as rolls become empty.
<esc> A Get Printer Status
Returns a single byte with the following bit meanings (1 = true).
Note that printer ready is returned as 03h (Ready and Top of form).
<esc> @ Reset Printer
lB 40
This command resets all parameters (Dot Tabs, Line Tabs, Bytes per Line, and so on) to
their default values and sets top-of-form as true.
Note: This command is acted upon immediately; any data still in the print buffer will be
lost.
<esc> *
lB 2A
This command resets all internal parameters to their default values.
Note: This command is acted upon when it is received.
<esc> f 1 n Skip "n" Lines
1B 66 1 ? n = the number of lines to skip
This command skips over the next "n" lines on the label.
Copyright © 2006, DYMO Corporation
Bit Meaning
0 Ready (paper in, no jam)
1 Top of form
2 Not used
3 Not used
4 Not used
5 No paper
6 Paper jam
7 Printer error (jam, invalid sequence, and so on)
Restore Default Settings
Page 17