Connector (Jp2) - Dymo LabelWriter 400 Series Technical Reference Manual

LabelWriter Twin Turbo Printer
Input current (idle)
Input current (typical)
Input current (max.)
LabelWriter Duo Printer
Input current (idle)
Input current (typical)
Input current (max.)
Note: The input current is ramped up as the 24 V is applied to the input to limit in-rush
current (there is a 2200µF filter capacitor at the input). After power is removed, allow
seven seconds for this circuit to reset before re-applying the input voltage.

Connector (JP2)

DC jack, 5.5 mm O.D. x 2.5 mm I.D. Center Positive
Copyright © 2006, DYMO Corporation
0.026 Amps
0.975 Amps (text only)
3.3 Amps based on printing a shipping label (30256) with a
maximum-size filled rectangle, after print head temperature
increases above ambient temperature.
At nominal print head temperature: 2.9 A
In graphics mode: 1.6 A
0.052 Amps
1.1 Amps (text only)
3.3 Amps based on printing a shipping label (30256) with a
maximum-size filled rectangle, after print head temperature
increases above ambient temperature.
At nominal print head temperature: 3.0 A
Page 13