Blade Installation - Honda HRU19RPU Owner's Manual & Service Record Booklet

Maintenance

Blade Installation:

1. Refit the new bolts, washers, nuts & blades to the disc with the curved side of the
blade facing upwards.
Tighten nuts to 300-400kg/cm (30-40Nm).
2. On completion, place the mower on a flat surface and pull the recoil starter slowly
several times to ensure that the cylinder is free of oil prior to starting.
3. Replace spark plug lead, turn fuel tap to the ON position.
4. Start mower with caution.
DIAGRAM No.
1
2
3
4
5
! WARNING
To avoid severe personal injury, disconnect the spark plug cap to prevent accidental
starting, and wear heavy gloves to protect your hands from the cutter blade.
CUTTER DISC
DESCRIPTION
Cutter Blade - High Lift
Cutter Blade - Low Lift
Bolt, blade setting, 10 x 20mm
Nut, self locking, 10mm
Washer, spring, 10mm
Washer, blade, 10mm
CUTTER DISC
WASHER SPRING
QUANTITY
CUTTER BLADE
24
2
2
4
4
4
4