Setting Codes; Delete Code - Siemens Codoor CD3500 Installation & User Manual

CD3500 & CD4000 Installation and User manual

Setting codes

With Codoor you can program up to 9 different codes (codes 01-09). Follow
these steps:
1. Press  then enter the 6-digit
programming code. Finish by pressing
. The red LED will flash slowly,
accompanied by simultaneous sounding of the buzzer.
2. Press  then enter the code number (01-09) you
want to program. Finish by pressing . The red LED
will flash faster.
Press  then enter the desired 4-digit code.
3.
Finish by pressing . The green LED will come
on for 2 seconds. To enter any additional
codes, repeat steps 3 and 4.
Exit programming mode by entering  00 . The
4.
buzzer sounds a rising tone to confirm.
NoTE! The unit automatically switches out of programming mode
into operating mode if no key is pressed within 10 seconds.
Programming must be done while the red LED flashes and the
buzzer sounds.

Delete code

Proceed like this:
Press  then enter the 6-digit
1.
programming code. Finish by pressing
. The red LED will flash slowly,
accompanied by simultaneous sounding
of the buzzer.
Press #, then enter the code (01 - 09) you wish to
2.
delete. Finish by pressing #. The green LED will come
on. If you wish to delete more than one code, repeat step 3 for each
code.
Exit programming mode by entering  00 . The
3.
buzzer sounds a rising tone to confirm.
 
 
 
0 0
 
 
# #
0 0
 
11
 
 
 
0 0
 
 
# #
0 0
 