Weber SP 100 LP Owner's Manual page 21

Step 22
Install swing table
You will need: swing table assembly, support rod,
support rod holder and swing table end bracket.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 28 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 28 (b). The rod should swing freely
inside the locking tab. Figure 28 (c).
(b)
Support rod
Figure 28
(c)
(a)
Insert one end of the hinge rod into the hole in the
frame. Figure 29 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 29 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 29 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
WARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Call
our Customer Service Center to order a new part.
Install support rod holder on leg. Figure 29 (d). Hook the
support rod into the support rod holder.
WARNING: The load limit for the swing table is
30 pounds.
Hinge rod
(a)
View from rear
of barbecue
(d)
21
(b)
Slot in frame
(view from below)
(c)
Figure 29