Weber SP 100 LP Owner's Manual page 20

Step 20
Install Lid
You will need: lid, two hinge pins and two hair pin
cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins.
Figure 26.
Figure 26
Hair pin cotter
Hinge pin
Step 21
Add tool holders, control panel and burner
control knobs
You will need: two tool holders, control panel and three
burner control knobs.
Hook the tool holders over the frame rail. Figure 27.
Set the control panel in place over both frame braces.
Hold the Crossover Ignition button up while setting the
control panel in place. Place your thumbs over the
control panel push-in buttons, and push them into the
frame brace until they snap into place. Figure 27 (a).
Push on the three burner control knobs. Figure 27 (b).
Tool holders
20
Hole in
frame brace
(a)
Control panel
push-in buttons
(b)
Figure 27