Weber SP 100 LP Owner's Manual page 14

Step 9
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner
valve. Place your hand underneath the bracket. Lift the
manifold, bracket and cooking box slightly and hook the
tab of the bracket onto the frame brace. Figure 10.
Figure 10
Frame brace
Manifold bracket
Step 10
Install tank panel assembly
You will need: tank panel assembly, 1/4-20 x 1 1/4 inch
bolt, 1/4-20 hex nut, nylon washer and a 7/16 inch
wrench.
Insert the tank panel tabs into the slots in the frame
brace. Figure 11.
Slots in frame brace
Slide tank panel up until notch at bottom of panel fits over
the cross brace. Insert one bolt with washer through the
hole in the bottom of the tank panel and through the
wheel frame. Add hex nut and tighten with the 7/16 inch
wrench. Figure 12.
Cross brace
14
Frame brace
Tank panel tabs
Figure 11
Figure 12