Weber Genesis 5000 LP Owner's Manual page 27

Step 28
Install tool holders, control panel, burner control
knobs and FlameCheck button
You will need: three tool holders, control panel, three
burner control knobs and FlameCheck button.
Hook the tool holders over the frame rail. Figure 44.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons and push them into the
frame brace until they snap into place. Figure 44 (a).
Push on the burner control knobs and FlameCheck
button. Figure 44 (b).
Hole in frame brace
Tool holders
Figure 44
Step 29
Secure side burner
Pull the right hand swing table up. Stand to the right side
of the barbecue. Slightly pull back both side burner
locks. Slide the side burner toward the control panel.
The locks will snap into the slots in the front and back of
the side burner. Figure 45.
into place.
(a)
Control panel
push-in buttons
(b)
27
Caution: Make sure both locks have snapped
View from top
Figure 45
Side view