Weber Genesis 5000 LP Owner's Manual page 12

Step 4
Continue frame assembly
You will need: frame assembly, wheel frame assembly,
front panel, caster frame, four 1/4-20 x 1/2 inch bolts,
four nylon washers and a 7/16 inch wrench.
Place the caster frame onto the tabs of the left frame
with the dimple to the inside. Figure 3. Place the wheel
frame onto the tabs of the right frame with the dimple to
the inside. The fuel scale decal should face away as
shown. Figure 3.
The leg tabs must be on the inside of the frames.
Add front panel with the hole down and to your right.
Add the washers to the bolts, insert in the holes as
shown. Only start the bolts at the wheel frame, figure 3
(a) & (b), and tighten the bolts at the caster frame.
Caster
Dimples to
frame
the inside
Only start
this bolt
Wheel
frame
Fuel scale
decal
Figure 3
Step 5
Complete frame assembly
You will need: partial frame assembly, one frame
connector with bushings, one frame connector without
bushings, four 1/4-20 x 2 inch bolts, four nylon washers
and a 7/16 inch wrench.
Hold the frame connector, bushing side down, between
the caster and wheel frame, above the front panel. Add
nylon washers to the bolts, put the bolts through the
frame and screw into the frame connector. Tighten.
The second frame connector has no bushings, place it
between the caster frame and the wheel frame. Add a
nylon washer to the bolt, put the bolts through the frame
and screw into the frame connector. Tighten. Figure 4.
12
Bushings down
Figure 4