Weber Genesis 5000 LP Owner's Manual page 19

Step 18
Install right end panel
You will need: right end panel (Number 3), 1/4-20 x 1 1/2
inch bolt, 1/4-20 hex nut, two nylon washers, 1/4-20 x 1/2
inch bolt, 1/4-20 wing nut and a 7/16 inch wrench.
Set the right end panel over the brace panel. Make sure
the gas supply hose is on the outside of the panel. Put
the washer on the 1/4-20 x 1 1/2 inch bolt and insert bolt
through both panels and frame brace. Add hex nut and
tighten. Figure 21.
Side burner hose
Figure 21
Place a nylon washer on the 1/4-20 x 1/2 inch bolt.
Insert the bolt through the top of the right end panel and
the brace panel. Put on wing nut and tighten. Figure 22.
Figure 22
19