Weber Genesis 5000 LP Owner's Manual page 14

Step 9
Install the three back panels
You will need: frame assembly, two plastic buttons and
the three back panels. (Number 2)
Place the bottom of one back panel on the back frame
connector, notches to the top. Set in place to the far left,
butting up against the caster frame. Repeat the
procedure with the the other two back panels. Figure 8.
With all three panels in place and flush with each other,
push in the plastic buttons. They should cover the
flanges of the panels up against the wheel and caster
frames. Figure 9.
Caster frame
Figure 8
Figure 9
Step 10
Install side burner locks
You will need: frame assembly, 2 side burner locks and a
7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side
burner lock. The "U" shape cut out of the lock slips down
over the bolt. Tighten with a wrench. Figure 10.
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame.
The "U" shape cut out slips up over the bolt.
Tighten with a wrench.
Wheel
frame
14
Figure 10