Id Type And Content - ZyXEL Communications SBG3300-N000 User Manual

NAT is not normally compatible with ESP in transport mode either, but the Device's NAT Traversal
feature provides a way to handle this. NAT traversal allows you to set up an IKE SA when there are
NAT routers between the two IPSec routers.
Figure 125 NAT Router Between IPSec Routers
A
Normally you cannot set up an IKE SA with a NAT router between the two IPSec routers because
the NAT router changes the header of the IPSec packet. NAT traversal solves the problem by adding
a UDP port 500 header to the IPSec packet. The NAT router forwards the IPSec packet with the UDP
port 500 header unchanged. In the above figure, when IPSec router A tries to establish an IKE SA,
IPSec router B checks the UDP port 500 header, and IPSec routers A and B build the IKE SA.
For NAT traversal to work, you must:
• Use ESP security protocol (in either transport or tunnel mode).
• Use IKE keying mode.
• Enable NAT traversal on both IPSec endpoints.
• Set the NAT router to forward UDP port 500 to IPSec router A.
Finally, NAT is compatible with ESP in tunnel mode because integrity checks are performed over the
combination of the "original header plus original payload," which is unchanged by a NAT device. The
compatibility of AH and ESP with NAT in tunnel and transport modes is summarized in the following
table.
Table 95 VPN and NAT
SECURITY PROTOCOL
AH
AH
ESP
ESP
Y* - This is supported in the Device if you enable NAT traversal.

20.7.7 ID Type and Content

With aggressive negotiation mode (see
SAs by ID type and content since this identifying information is not encrypted. This enables the
Device to distinguish between multiple rules for SAs that connect from remote IPSec routers that
have dynamic WAN IP addresses.
Regardless of the ID type and content configuration, the Device does not allow you to save multiple
active rules with overlapping local and remote IP addresses.
With main mode (see
provide identity protection. In this case the Device can only distinguish between different incoming
SAs that connect from remote IPSec routers that have dynamic WAN IP addresses. The Device can
SBG3300-N Series User's Guide
NAT Router
MODE NAT
Transport N
Tunnel N
Transport Y*
Tunnel Y
Section 20.7.4 on page
Section 20.7.4 on page
291), the Device identifies incoming
291), the ID type and content are encrypted to
Chapter 20 IPSec VPN
B
293