P-871H Series User's Guide
Table 16 VLAN: Static VLAN (continued)
LABEL
VID
Active
Name
Delete
Cancel
6.3.3 Configure VLAN Port Settings
To configure the VLAN settings on a port, click the VLAN Port Setting link in the VLAN
Status screen.
Figure 20 VLAN: VLAN Port Setting
The following table describes the labels in this screen.
Table 17 VLAN: VLAN Port Setting
LABEL
Port
PVID
Apply
Cancel
6.4 Port-based VLAN Setup
Port-based VLANs are VLANs where the packet forwarding decision is based on the
destination MAC address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if
you wish to allow two subscriber ports to talk to each other, for example, between conference
rooms in a hotel, you must define the egress (an egress port is an outgoing port, that is, a port
through which a data packet leaves) for both ports.
48
DESCRIPTION
This field displays the ID number of the VLAN group. Click the number to edit the
VLAN settings.
This field indicates whether the VLAN settings are enabled (Yes) or disabled (No).
This field displays the descriptive name for this VLAN group.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
DESCRIPTION
This field displays the Ethernet port number or the VDSL port (VDSL).
Enter a number between 1and 4094 as the port VLAN ID.
Click Apply to save the changes
Click Cancel to start configuring the screen again.
Chapter 6 VLAN