Setup; Ac Power; Ac Plug; Power Linking - Chauvet Q-Wash User Manual

Setup

3. Setup

AC Power

AC Plug

Power Linking

Fuse Replacement

-6-
The Q-Wash™ 419Z-LED has an auto-ranging power supply that works with an input
voltage range of 100~240 VAC, 50/60 Hz. To determine the power requirements for
each Q-Wash™ 419Z-LED, refer to the label affixed to the product. You can also refer to
the Technical Specifications
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the CHAUVET®
website: www.chauvetpro.com.
Always connect this product to a protected circuit with an appropriate electrical ground to
avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The Q-Wash™ 419Z-LED comes with a power input cord terminated with a Neutrik®
powerCON® A connector and an Edison power cord adapter. If the power cord adapter
that came with your product has no plug or you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
The Q-Wash™ 419Z-LED supports power linking. You can power link up to:
· 5 products at 120 VAC,
· 9 products at 208 VAC, or
· 9 products at 230 VAC
This product comes with a power input cord. This product does not come with a power
linking cable; however, a power linking cable is available as an option.
Make sure to disconnect the product's power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
The stand-alone battery charger has no external fuse. However, the
flight case/charger comes with a replaceable fuse
(T 6.3 A @ 250 V).
To change the fuse on the flight case/charger, do the following:
1. Disconnect the product from the power outlet.
2. With a Phillips #2 head screwdriver, unscrew the fuse holder
cap from its housing.
3. Remove the blown fuse and replace it with a good fuse of the
same type and rating (T 6.3 A @ 250 V).
4. Screw the fuse holder cap back in its place and reconnect
power.
section in this manual.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Screw Color
Brown Yellow or Brass
Blue Silver
Green
Q-Wash™ 419Z-LED User Manual