Edit Custom Programs; Master/Slave - Chauvet Q-Wash User Manual

Operation
Edit Custom
Programs

Master/Slave

-12-
This setting allows the programming of up to 49 steps in the CUSTOM running mode.
1. Go to STAND ALONE > EDIT.
2. Select STEP.
3. Set the program step (01~49).
a. Select PAN or TILT.
i. Set the position value (000~255).
ii. Repeat for the other position
b. Select DIMMER.
i. Set the intensity value (000~255).
c. Select RED, GREEN, BLUE, or WHITE.
i. Select the color value (000~255).
ii. Repeat for the other colors.
d. Select STROBE.
i. Set the frequency value (000~255).
e. Select ZOOM.
i. Set the angle value (000~255).
f. Select TIME.
i. Select the step duration (000~255).
g. Repeat for the other steps
4. Select USE.
a. Select YES to save the program or NO to discard.
The Master/Slave mode allows a group of Q-Wash™ 419Z-LEDs (slave products) to
simultaneously duplicate the output of another Q-Wash™ 419Z-LED (master product)
without a DMX controller.
1. Set each of the slave products:
a. Go to STAND ALONE > RUN.
b. Select SLAVE.
2. Set the master product:
a. Set the running mode to DMX (see
b. Select an Auto, Custom, or Static program as explained in
Programs or
· The master product is the one that runs a program whether in Auto, Custom, or Static
Color mode.
· Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master product.
· The master product should be the first product in the daisy chain.
DMX
Static Control.
Control).
Auto/Custom
Q-Wash™ 419Z-LED User Manual