Integra DTR-20.2 Instruction Manual page 66

■
The functions don't work
To use , you must make an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
■
The functions System On/Auto Power On and
Direct Change don't work for components
connected via
These functions don't work when Zone 2 is turned
on.
■
When performing "Audyssey 2EQ
Correction and Speaker Setup", the
measurement fails showing the message
"Ambient noise is too high.".
This can be caused by any malfunction in your
speaker unit. Check if the unit produces normal
sounds.
■
The following settings can be made for the
composite video input
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
source that you want to set, press Setup.
2. Use / to change the setting.
3. Press the input selector button for the input source that you
want to set when you've finished.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
CBL/SAT, or Game input.
If you have a games console connected to the composite
video input, and the picture isn't very clear, you can
attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
Integra/Onkyo is not responsible for damages (such as
CD rental fees) due to unsuccessful recordings caused
by the unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
En
66
17
connection and an
17
® Room
—
Important Note Regarding Video Playback
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
the HDMI OUT. However, if the picture quality of the
source is poor, upconversion may make the picture worse
or disappear altogether.
In this case, try the following:
1
If the video source is connected to a component
video input, connect your TV to the COMPO-
NENT VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2
On the main menu, select
Assign , and then select
"
Select the relevant input selector, and assign it to
➔
36).
"- - - - -" (
3
On the main menu, select
Assign , and then select
"
➔
Input . 37):
" (
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to .
"IN1"
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to .
"IN2"
If the video source is connected to composite video
input, select the relevant input selector, and assign it
to .
"- - - - -"
1. Input/Output
"
2. HDMI Input .
" "
1. Input/Output
"
3. Component Video
"