Integra DTR-20.2 Instruction Manual page 24

Using Audyssey 2EQ
To create a listening environment in your home theater
that all listeners will enjoy, Audyssey 2EQ takes measure-
ments at up to three positions within the listening area.
Position the microphone at ear height of a seated listener
with the microphone tip pointed directly at the ceiling
using a tripod. Do not hold the microphone in your hand
during measurements as this will produce inaccurate
results.
First measurement position
Also referred to as the Main Listening Position this
refers to the most central position where one would
normally sit within the listening environment. 2EQ
uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum
crossover value for the subwoofer.
Second measurement position
The right side of the listening area.
Third measurement position
The left side of the listening area.
The distances from position
at least 1 meter.
: Listening area
Note
• Make the room as quiet as possible. Background noise and Radio
Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other
devices. Turn off the cell phone (even if it is not in use) or place
it away from all audio electronics.
• The microphone picks up test tones which played through each
speaker as Audyssey 2EQ Room Correction and Speaker Setup
run.
• Audyssey 2EQ Room Correction and Speaker Setup cannot be
performed while a pair of headphones is connected.
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver
is connected.
En
24
®
to and to must be
TV
to : Listening position
2
Set the speaker setup microphone at the Main Lis-
tening Position 1, and connect it to the Setup Mic
jack.
Setup Mic jack
The speaker setting menu appears.
Note
• The on-screen setup menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected to
the MONITOR OUT V or the COMPONENT VIDEO
OUT, use the AV receiver's display when changing set-
tings.
3
Press Enter.
Audyssey 2EQ Room Correction and Speaker Setup starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker Setup
runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and
Speaker Setup unless you want to cancel the setup.
4
Place the setup microphone at the next position,
and then press Enter.
Audyssey 2EQ performs more measurements. This
takes a few minutes.
5
When prompted, repeat step 4.
6
Use / to select an option, and then press Enter.
2EQ: Auto Setup
- - Review Speaker Configuration - -
Subwoofer
Front
Center
Surround
Surr Back
Surr Back Ch
Save
Cancel
The options are:
Save:
Save the calculated settings and exit
®
Audyssey 2EQ
Speaker Setup
Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
Note
• You can view the calculated settings for the speaker con-
figuration, speaker distances, and speaker levels by using
/ .
Speaker setup
microphone
Yes
Full Band
TV
40Hz
100Hz
120Hz
2ch
Room Correction and