Using Zone 2 - Integra DTR-20.2 Instruction Manual

1

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
Zone2 Off
Zone 2 indicator
1
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Zone 2 indicator lights.
To select AM or FM, press the Tuner input selector
button repeatedly.
To select the same source as that of the main room,
press Zone 2 repeatedly until "Z2 Selector:
Source" appears on the display.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
2
To turn off Zone 2, press Off.
Note
• Only analog input sources are output by Zone 2. Digital input
sources are not output. If no sound is heard when an input source
is selected, check to make sure it's connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and Direct
Change functions do not work.
Controlling Zone 2 with the Remote
Controller
En
52
Input selector buttons
On/Standby
Zone2
Input Selector buttons
Muting
VOL /
1
Press Zone2 and then press On/Standby.
Zone 2 turns on, the Zone 2 indicator lights.
2
To select an input source for Zone 2, press Zone2,
followed by an Input Selector.
To select AM or FM, press the Tuner input selector
repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press Zone2 followed by On/
Standby.
Note
• To control Zone 2, you must press the remote controller's
Zone2 first.
Adjusting the Volume for Zone 2
■
Operating with the remote controller
Press Zone2, and then use VOL / .
■
Operating on the AV receiver
Use Zone 2 Level / .
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zone 2
■
Operating with the remote controller
Press Zone2 followed by Muting.
Tip
• To unmute, press Zone2 followed by Muting again.
• Zone 2 can also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zone 2
Zone 2
Tone
,
1
On the AV receiver, press Zone 2.
2
Press the AV receiver's Tone repeatedly to select
"Bass", "Treble" or "Balance".