List Of Pop-Up And Descriptions - Crown DriveCore I-Tech 4x3500 HD Operation Manual

7 Advanced Operation
7.4 List of Pop-Up Boxes and Descriptions
These messages may appear on the LCD screen.
If N/A is displayed, the particular menu has been
locked out via System Architect software.
page 28
"Lockout" is displayed when front panel lockout has been enabled from either the
Lockout
software or front panel. It prevents any changes from the display.
USB "USB Lockout" is displayed when USB lockout has been enabled from the software.
Lockout It disables all USB functions.
Invalid
An invalid subnet mask was selected.
Subnet
Invalid
An invalid IP address was selected.
Address
Preset
The selected preset has been successfully loaded.
Loaded
The selected address has been modified. Applies to HiQnet node address, IP address
Address
Changed and subnet mask.
DHCP
The current state of DHCP has been changed to either ON or OFF.
Changed
USB Fault
The USB drive is drawing more than 500mA of current.
Overcurrent!
The selected USB device file cannot be loaded because it is not valid. This is most
Device File
is not valid! likely a device file formatting problem. Try to create a new device file.
Loading File Loading the preset or device file from the USB device failed. This could be due to the
FAILED! format or contents of the file.
Loading File
Loading the preset or device file from the USB device was successful.
Successful!
Confirm Change
Displayed after the first button press. To continue, the user must release the button
(Press knob again)
and press it again.
Confirm Change Displayed after the first button press has been released. To continue, the user must
(Press and Hold)
press the button again.
Press and Hold Displayed after the second button press. To continue, the user must continue to hold
(Hold knob) the button for at least 2 seconds.
To modify this parameter, the encoder button must be pressed twice with the second
Change
press being held down for at least 2 seconds. This message indicates that the encoder
cancelled
button was not properly pressed and/or held down.
No Change
The selected object to change has not been modified from the current value.
Selected
The display does not have permission to change this parameter. The display observes HiQnet
Changes
access rights role 4. Individual screens' parameters can be user defined as Write Protected
Disabled
and/or Read Protected. When a parameter is Read Protected, a "N/A" is displayed.
Change
The selected change was not made. It may have been out of range or invalid.
Failed!
I-Tech HD DriveCore Series Power Amplifiers
Operation Manual