Installing Logs - Desa UNVENTED (VENT-FREE) PROPANE/LP GAS FIREPLACE Owner's Operating & Installation Manual

INSTALLING
Continued
20
INSTALLING LOGS (Split Oak Design Models)
Failure to position the parts in accordance with these diagrams or failure to use
only parts specifically approved with this heater may result in property damage or
personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing.
It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom of
the logs fit over the grate prongs (see Figure 23). Push back of logs flush with metal grate
bar. Note: 18" model has only one front log.
2. Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in the
bottom of the log fit over the grate. Bring the log forward next to the metal posts. The pegs
on the log must be on top (see Figure 24).
3. Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the
peg on the log is on top (see Figure 25).
4. Place the top middle log (#4) on the bottom middle log (#2). Make sure the pegs of the
bottom middle log fit securely in the holes of the top middle log (see Figure 26).
Front Log (#1L)
Notch
Grate
Prongs
Metal Grate Bar
Figure 23 - Installing Front Logs
(#1L and #1R)
Groove
in Back
of Log
Grate
Prong
Rear
Burner
Figure 25 - Installing Rear Log (#3)
WARNING
Peg
Front Log (#1R)
Groove
Metal Post
Groove
Metal Post
Peg
Rear Log (#3)
Hole
Groove
in Back
of Log
Grate
Prong
Figure 26 - Installing Top Log (#4)
Bottom Middle Log (#2)
Figure 24 - Installing Bottom
Middle Log (#2)
Top Middle Log (#4)
Peg
Peg
Peg
Grate
Hole
Bottom
Middle Log
103415