Assembling And Attaching Brass Trim - Desa UNVENTED (VENT-FREE) PROPANE/LP GAS FIREPLACE Owner's Operating & Installation Manual

INSTALLING
Continued
10
ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM
(Included with Mantel Accessory)
IMPORTANT: If you are recessing the firebox in a wall, do not attach brass trim at this time. See
page 13.
Note: The instructions below show assembling and attaching brass trim to fireplace.
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates with set screws, and two shims in the hardware
packet.
3. Align shim under adjusting plate as shown in Figure 6.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 6).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 6).
6. While firmly holding edges of brass trim together, tighten both set screws on the adjusting
plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
Side Brass Trim
Slot
8. Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the as-
sembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on
side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over
hanging screws.
Assembled
Brass Trim
Figure 7 - Attaching Brass Trim to Fireplace
Set Screws
Adjusting
Plate
Shim
Mitered Edge
Figure 6 - Assembling Brass Trim
Top Brass Trim
Slot
Trim Hanging
Screws
Hanging
Notches on Trim
103415