Replacing A Headlight Bulb; Replacing The Tail/Brake Light Bulb - Yamaha BWS CW50 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing a headlight bulb

If a headlight bulb burns out, replace it
as follows.
1. Place the scooter on the center-
stand.
2. Remove cowling A. (See page
6-6.)
3. Unhook the headlight bulb holder,
and then remove the burnt out
bulb.
6
ZAUM0901
1. Unhook.
2. Headlight bulb
3. Headlight bulb holder
4. Place a new bulb into position, and
then secure it with the bulb holder.
5. Install the cowling.
6. Have a Yamaha dealer adjust the
headlight beam if necessary.
EAUM2930
Replacing the tail/brake light
bulb
1. Remove the tail/brake light lens by
removing the screws.
ZAUM0573
1. Screw
3
2. Remove the burnt-out bulb by
1
pushing it in and turning it counter-
2
clockwise.
EAU24133
1
ZAUM0904
1. Tail/brake light bulb
3. Insert a new bulb into the socket,
4. Install the lens by installing the
6-22
1
push it in, and then turn it clock-
wise until it stops.
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10681]