Checking The Brake Fluid Level - Yamaha BWS CW50 Owner's Manual

Checking the brake fluid level

Before riding, check that the brake fluid
is above the minimum level mark.
Check the brake fluid level with the top
of the reservoir level. Replenish the
brake fluid if necessary.
ZAUM0900
1. Minimum level mark
Specified brake fluid:
DOT 4
WARNING
Improper maintenance can result in
loss of braking ability. Observe
these precautions:
PERIODIC MAINTENANCE AND ADJUSTMENT
●
EAU32345 Insufficient brake fluid may al-
low air to enter the brake sys-
tem, reducing
performance.
●
Clean the filler cap before re-
moving. Use only DOT 4 brake
fluid from a sealed container.
● Use only the specified brake flu-
id; otherwise, the rubber seals
may deteriorate, causing leak-
1
age.
●
Refill with the same type of
brake fluid. Adding a brake fluid
other than DOT 4 may result in a
harmful chemical reaction.
● Be careful that water does not
enter the brake fluid reservoir
when refilling. Water will signifi-
cantly lower the boiling point of
the fluid and may result in vapor
lock.
EWA15990
NOTICE
Brake fluid may damage painted sur-
faces or plastic parts. Always clean
up spilled fluid immediately.
As the brake pads wear, it is normal for
the brake fluid level to gradually go
braking down. A low brake fluid level may indi-
cate worn brake pads and/or brake sys-
tem leakage; therefore, be sure to
check the brake pads for wear and the
brake system for leakage. If the brake
fluid level goes down suddenly, have a
Yamaha dealer check the cause before
further riding.
ECA17640
6-15
6