Final Transmission Oil - Yamaha BWS CW50 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm up the final
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the center-
stand.
6
3. Place an oil pan under the final
transmission case to collect the
used oil.
4. Remove the final transmission oil
filler cap and its O-ring from the fi-
nal transmission case.
EAU20066
1
ZAUM0153
1. Final transmission oil drain bolt
2. Final transmission oil filler cap
5. Remove the final transmission oil
drain bolt and its gasket to drain
the oil from the final transmission
case.
6. Install the final transmission oil
drain bolt and its new gasket, and
then tighten the bolt to the speci-
fied torque.
Tightening torque:
Final transmission oil drain bolt:
17 Nm (1.7 m·kgf, 12 ft·lbf)
7. Refill with the specified amount of
the recommended final transmis-
sion oil. WARNING! Make sure
that no foreign material enters
2
8. Install the final transmission oil fill-
9. Check the final transmission case
6-8
the final transmission case.
Make sure that no oil gets on the
tire or wheel.
[EWA11311]
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.11 L (0.12 US qt, 0.10 Imp.qt)
er cap and its new O-ring, and then
tighten the oil filler cap.
for oil leakage. If oil is leaking,
check for the cause.