Self-Diagnosis Device; Clock Mode - Yamaha MAJESTY 400 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
procedure.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
1 2. If the indicator does not come on,
have a Yamaha dealer check the
electrical circuit.
2

Self-diagnosis device

3
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
4
If any of those circuits are defective, the
multi-function display will indicate a
5
two-digit error code.
If the multi-function display indicates
6
such an error code, note the code num-
ber, and then have a Yamaha dealer
check the vehicle.
7
CAUTION:
8
If the multi-function display indi-
cates an error code, the vehicle
9
should be checked as soon as pos-
sible in order to avoid engine dam-
age.
This model is also equipped with a
self-diagnosis device for the immobiliz-
er system.
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
multi-function display will indicate a
two-digit error code when the key is
turned to "ON".
NOTE:
If the multi-function display indicates er-
ror code 52, this could be caused by
transponder interference. If this error
appears, try the following.
1. Use the code re-registering key to
start the engine.
NOTE:
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
ECA11790
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
If the multi-function display indicates
any error codes, note the code number,
and then have a Yamaha dealer check
the vehicle.

Clock mode

To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
5. Push the "SELECT" button and
3-8
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.
Pushing the "SELECT" button for
at least two seconds switches the
clock display to the ambient tem-
perature display.