Yamaha MAJESTY 400 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
sible in order to avoid engine dam-
age.
This model is also equipped with a
self-diagnosis device for the immobiliz-
1
er system.
If any of the immobilizer system circuits
2
are defective, the immobilizer system
indicator light will flash, and then the
3
multi-function display will indicate a
two-digit error code (e.g., 51, 52, 53)
4
when the key is turned to "ON".
NOTE:
5
If the multi-function display indicates er-
ror code 52, this could be caused by
6
transponder interference. If this error
appears, try the following.
7
1. Use the code re-registering key to
start the engine.
8
NOTE:
Make sure there are no other immobi-
9
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
If the multi-function display indicates
any error codes, note the code number,
and then have a Yamaha dealer check
the vehicle.
Clock mode
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
3-8
5. Push the "SELECT" button and
then release it to start the clock.
Pushing the "SELECT" button for
at least two seconds switches the
clock display to the ambient tem-
perature display.
Ambient temperature display
This display shows the ambient tem-
perature from –10 °C to 50 °C in 1 °C
increments. The temperature displayed
may vary from the ambient tempera-
ture. Pushing the "SELECT" button for
at least two seconds switches the am-
bient temperature display to the clock
display.
NOTE:
G
If the ambient temperature falls be-
low –10 °C, a lower temperature
than –10 °C will not be displayed.
G
If the ambient temperature climbs
above 50 °C, a higher temperature
than 50 °C will not be displayed.
G
The accuracy of the temperature
reading may be affected when
riding slowly (approximately under
20 km/h (12.5 mi/h)) or when