Yamaha MAJESTY 400 Owner's Manual page 56

PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
NOTE:
Make sure that the O-rings are properly
2
seated.
8. Install the washer and the engine
3
oil drain bolt, and then tighten the
drain bolt to the specified torque.
4
Tightening torque:
Engine oil drain bolt:
5
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
NOTE:
6
Make sure that the washer is properly
seated.
7
9. Add the specified amount of the
8
recommended engine oil, and then
install and tighten the oil filler cap.
9
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.50 L (1.59 US qt) (1.32 Imp.qt)
With oil filter element replacement:
1.70 L (1.80 US qt) (1.50 Imp.qt)
CAUTION:
G
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Be sure no foreign material en-
ters the crankcase.
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
11. Reset the oil change indicator ac-
cording to the following procedure.
To reset the oil change indicator
1. Turn the key to "ON".
6-14
2. Hold the "OIL CHANGE" button
pushed for two to eight seconds.
ECA11670
1. "OIL CHANGE" button
3. Release the "OIL CHANGE" but-
ton, and the oil change indicator
will go off.
NOTE:
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
periodic oil change to be indicated at
the correct time. To reset the oil change
indicator before the periodic oil change
interval has been reached, follow the
above procedure, but note that the indi-
1