Removing And Installing Cowlings And Panels - Yamaha MAJESTY 400 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Removing and
cowlings and panels
The cowlings and panels shown need
1
to be removed to perform some of the
maintenance jobs described in this
chapter. Refer to this section each time
2
a cowling or panel needs to be re-
moved and installed.
3
1
4
5
6
6
7
1. Panel A
2. Cowling C
8
3. Cowling A
4. Cowling B
9
5. Panel B
6. Cowling E
EAU18711
installing
1. Cowling D
2 3 4
Cowling A
To remove the cowling
1. Open
page 3-14.)
2. Remove the quick fasteners in the
5
rear storage compartment, and
then pull the cowling off as shown.
NOTE:
The quick fastener is removed by push-
ing the center pin in with a screwdriver,
and then pulling the fastener out.
1
EAU34281
the rider seat. (See
6-6
1
1. Quick fastener
2. Cowling A
To install the cowling
1. Place the cowling in the original
position, and then install the quick
fasteners.
NOTE:
To install the quick fastener, push the
center pin out so that it will protrude
from the fastener head, insert the fas-
tener into the cowling, and then push
the protruding pin in until it is flush with
the fastener head.
2. Close the rider seat.
Cowling B
To remove the cowling
1. Remove the screws.
2