Coolant - Yamaha XMAX YP250R Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
6. Refill with the specified amount
of the recommended final trans-
mission oil, and then install and
tighten the oil filler cap. WAR-
NING! Make sure that no
foreign material enters the final
transmission case. Make sure
that no oil gets on the tire or
wheel.
[EWA11311]
Recommended final transmission
oil:
See page 8-1
Oil quantity:
0.25 L (0.26 US qt, 0.22 Imp.qt)
6
7. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.

Coolant

The coolant level should be checked
before each ride. In addition, the coo-
lant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level surfa-
ce and hold it in an upright posi-
tion.
TIP
●
The coolant level must be chec-
ked on a cold engine since the
level varies with engine tempera-
ture.
●
Make sure that the vehicle is
positioned straight up when
checking the coolant level. A
slight tilt to the side can result in
a false reading.
2. Check the coolant level through
the check window.
6-12
EAU20070 TIP
The coolant should be between the
minimum and maximum level marks.
FULL
LOW
EAUS1274
1. Maximum level mark
2. Minimum level mark
3. Coolant level check window
3. If the coolant is at or below the
minimum level mark, remove the
right floorboard mat by pulling it
up.
4. Open the reservoir cap, and then
add coolant to the maximum
level mark. WARNING! Remove
only the coolant reservoir cap.
Never attempt to remove the
radiator cap when the engine is
hot. NOTICE: If coolant
[EWA15161].
is not available, use distilled
water or soft tap water instead.