Coolant - Yamaha XMAX YP250R Owner's Manual

Tightening torque:
Final transmission oil drain bolt:
22 Nm (2.2 m·kgf, 15.9 ft·lbf)
6. Add the specified amount of the
recommended final transmission
oil, and then install and tighten
the oil filler cap.
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.25 L (0.26 US qt) (0.22 Imp.qt)
s WARNING
s
● Make sure that no foreign
material enters the final trans-
mission case.
●
Make sure that no oil gets on
the tire or wheel.
7. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
PERIODIC MAINTENANCE AND MINOR REPAIR

Coolant

The coolant level should be checked
before each ride. In addition, the coo-
lant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level surfa-
ce and hold it in an upright posi-
tion.
NOTE:
●
The coolant level must be chec-
EWA11310
ked on a cold engine since the
level varies with engine tempera-
ture.
●
Make sure that the vehicle is
positioned straight up when
checking the coolant level. A
slight tilt to the side can result in
a false reading.
2. Check the coolant level through
the check window.
EAU20070 NOTE:
The coolant should be between the
minimum and maximum level marks.
EAUS1273
1. Maximum level mark
2. Minimum level mark
3. Coolant level window
3. If the coolant is at or below the
4. Open the reservoir cap, and then
6-12
1
FULL
LO W
2
3
minimum level mark, remove the
right floorboard mat by pulling it
up.
add coolant to the maximum
level mark.
6