Adjusting The Shock Absorber Assemblies; Sidestand - Yamaha XMAX YP250R Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Adjusting the shock
absorber assemblies
Each shock absorber assembly is
equipped with a spring preload adjus-
ting ring.
CAUTION:
3
Never attempt to turn an adjusting
mechanism beyond the maximum
or minimum settings.
s WARNING
s
Always adjust both shock absorber
assemblies equally, otherwise poor
handling and loss of stability may
result.
Adjust the spring preload as follows.
To increase the spring preload and
thereby harden the suspension, turn
the adjusting ring on each shock
absorber assembly in direction (a). To
decrease the spring preload and the-
reby soften the suspension, turn the
adjusting ring on each shock absor-
ber assembly in direction (b).
EAU14880
ECA10100
1. Spring preload adjusting ring
2. Position indicator
EWA10210
NOTE:
Align the appropriate notch in the
adjusting ring with the position indica-
tor on the shock absorber.
Spring preload setting:
Minimum (soft):
1
Standard:
1
Maximum (hard):
4

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
1. Sidestand switch
2. Sidestand
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain
situations. (See further down for an
explanation of the ignition circuit cut-
off system.)
3-17
EAU15301