Replacing A Front Turn Signal Light Bulb - Yamaha XCITY VP250 Owner's Manual

WARNING
Headlight bulbs get very hot. There-
fore, keep flammable products away
from a lit headlight bulb, and do not
touch the bulb until it has cooled
down.
5. Place a new headlight bulb into po-
sition, and then secure it with the
bulb holder.
CAUTION:
Take care not to damage the follow-
ing parts:
G Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
PERIODIC MAINTENANCE AND MINOR REPAIR
G
EWA10790 Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
ECA10650
1. Do not touch the glass part of the bulb.
6. Connect the headlight coupler.
7. Install the headlight bulb cover.
8. Install the cowling.
9. Have a Yamaha dealer adjust the
headlight beam if necessary.
Replacing a front turn signal
light bulb
CAUTION:
It is advisable to have a Yamaha
dealer perform this job.
1. Place the scooter on the center-
2. Remove cowling A. (See page
3. Remove the socket (together with
ZAUM0465
1. Turn signal light bulb socket
4. Remove the defective bulb by
6-25
stand.
6-5.)
the bulb) by turning it counter-
clockwise.
pushing it in and turning it counter-
clockwise.
EAUT1260
ECA10670
6
1