Yamaha XCITY VP250 Owner's Manual page 44

PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
The engine oil should be between the
minimum and maximum level marks.
1
2
3
ZAUM0685
1. Engine oil filler cap
2. Maximum level mark
6
3. Minimum level mark
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
1
ZAUM0686
1. Engine oil drain bolt
4. Check the washer for damage and
replace it if necessary.
ZAUM0129
1. Engine oil drain bolt
2. Washer
5. Install the washer and the engine
NOTE:
1
1 Make sure that the washer is properly
seated.
6. Add the specified amount of the
CAUTION:
G
2
1
6-8
oil drain bolt, and then tighten the
drain bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
1.20 L (1.27 US qt) (1.06 Imp.qt)
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
ECA11670