Edge Storage Tab - Setting The Edge Storage Movie And Still Image Function; Periodical Execution; Trouble Sending; Memory Card - Sony Ipela SNC-CX600W User Manual

None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits of
the year (2 digits), month (2 digits), date (2 digits),
hour (2 digits), minute (2 digits), second (2 digits),
and sequential number (2 digits), thus adding 14-
digit number to the image file name.

Periodical execution

You can set to send e-mails periodically.
Image file name
Type the file name of the image attached to the e-mail
using up to 10 alphanumeric characters, – (hyphen) and
_ (under score).
The actual image file name will be the specified image
file name with a suffix and the extension .jpg.
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits the
year (2 digits), month (2 digits), date (2 digits), hour
(2 digits), minutes (2 digits) and seconds (2 digits),
and sequential number (2 digits), thus adding a 14-
digit number to the image file name.

Trouble sending

Set to send an e-mail if a problem with a memory card
has been found.
Enable
Select the checkbox to enable the sending of problem
reports.
Continuous sending
Set whether to enable continuous e-mail sending.
When the checkbox is selected, an e-mail will be sent
once an hour.
Recipient e-mail address
Type the recipient's e-mail address within 64 characters.
OK/Cancel
See "Buttons common to every menu" on page 19.
50
Setting the Action output — Action output Menu
Edge Storage Tab — Setting the
Edge Storage movie and still image
function
With Edge Storage, video or audio signal can be
recorded from the alarm detection results, such as
network block, recorded video and audio can be
streamed with the same protocol as the real-tim
streaming.
Notes
• The frame rate and operability on the viewer may be
reduced during movie or still image recording.
• The actual interval of recording a still image may be
longer than the interval you set.
• Stop the Edge Storage recording before you turn off
the power of the camera with a memory card inserted.
• Before you remove or insert a memory card, stop the
Edge Storage recording and turn off the power of the
camera.
• Before using a memory card, format it using the
computer, or by Format memory card in the
Initialize tab of the System menu (page 21).
• A maximum of 500 movie records can be saved to an
memory card. If the checkbox of Overwrite is not
selected when the number of records reaches 500, new
recordings cannot be made. If the checkbox of
Overwrite is selected when the number of records
reaches 500, the unit will begin to overwrite old
records in ascending chronological order.
• Overwrite is not available for a memory card of less
than 4 GB.
• When you record the H.246, set the video codec as
follows:
– Set the Bit rate below 2000 kbps.
– Set the Frame rate below 30 fps.
– Set the I-picture interval to 1 second.
• When you record the JPEG with image size 1280 ×
720, set the video codec as follows:
– Set the Frame rate to 1 fps.
– Set the Image quality below 5.
• When you record, set the Image codec 2 and Image
codec 3 of the Video codec tab in the Video / Audio
menu to Off.
• When you set the image codec to VBR (CBR: Off) of
H.264 and record it, the recorded data may become
very large and the video/audio may be interrupted
depending on the setting for recording and scene. Be
sure to check the setting and environment of video
codec before use.
Common setting

Memory card

Display the available free space of external memory.