Attach Runabout To Adult Bike And Secure Seat Post Clamp; Insert Safety Flag, Check Tire Pressure, And Recheck All Fasteners; Straddle The Adult Bike While The Child Climbs Onto The Trailer Bike - Schwinn Runabout 13-SC250 Owner's Manual

STEP 8

Attach Runabout to adult bike and secure seat post clamp

8A
8A. Place the Runabout behind the adult bike with the seat post clamp against the adult
bike seat post. The seat post should rest in the valley of the seat post clamp.
8B. Place the seat post clamp plate over the seat post and tighten all four bolts by hand.
8C. Position the Runabout behind the adult bike so the coupler assembly, trailer arm, and
bike are in a straight line. Tighten each bolt one turn with the Allen wrench.
8D. Tighten all four bolts in a crisscross pattern (1,2,3,4 then repeat) until they are tightened
equally, and the gap between the clamp plate and coupler is even on both sides.
STEP 9

Insert safety flag, check tire pressure, and recheck all fasteners

9A
9A. Locate the safety flag, poles, and plastic joiner. Join the two poles by inserting one pole
into each end of the joiner.
9B. Insert the safety flag assembly into the bracket next to the trailer bike's rear hub nut.
9C. The completed product should look like this. Check the tire pressure and inflate to
correct PSI reading indicated on the tire sidewall. Re-check all fasteners to make sure
that they are all secure.
WARNING! Always use the safety flag when riding with this product!
STEP 10

Straddle the adult bike while the child climbs onto the trailer bike

WARNING! The adult bike kickstand is not designed to support the additional weight of a child seated
on the trailer bike. The adult pulling the child should always straddle the adult bike whenever the child is
seated on the trailer bike, or getting on and off the trailer bike!
WARNING! Always wear an approved safety helmet when riding!
8B
9B
8C
9C
7
8D
1
4
3 2